Xtramus APMPT-4 V2.4 - Manual (Page 133)

133
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
 Add VLAN: Selecting this function will enable the VLAN Setup option on Common Settings.
VLAN (Virtual LAN) is a group of hosts with common requirements that communicate within the
same Broadcast domain regardless of the physical location. By clicking the Setup button, you can
configure CoS (class of service) and VID (VLAN ID) on the pop-up VLAN Setup window. Click
Apply and apply all the changes you‟ve made here.
 Enable Flow Control: When enabling this function, the transmitting rate will drop if traffic overflow
occurs. This function must be enabled under full-duplex.
 Global:
 Tx Payload: You can set the content of the transmitting packets with the Payload scroll-down
menu.
 Wait for Check Result: The system will halt for the time you set here before checking test result.
 Wait for Read Counter: The system will halt for the set microseconds before read the counters.
This function is useful for counters since they are stored in memory buffer and the final counter
value might take some time to read. Duration time between frames. Increasing Frame Gap
reduces the fail rate, while 96 bit-time is wirespeed.
 Enable X-TAG and Check: X-TAG is a 12-byte tag which is developed by Xtramus and
embedded at 45th~56th bytes of each testing frames generated by Rapid-Matrix for multi-stream
tests. X-TAG will be added to all the testing frames generated by APMPT-4.
 Enable X-TAG offset: X-TAG is a 12-byte tag which is developed by Xtramus and embedded at
45th~56th bytes of each testing frames generated by Rapid-Matrix for multi-stream tests. X-TAG
will be added to all the testing frames generated by NuApps-MultiUnits-RM.
 Insert Elongated Frame Gap: When enabling this function, 1 bit-time of frame gap will be
inserted after a certain amount of packets are transmitted, and therefore, decrease packet loss.
 Transmit by Sequence: Transmit packet by port sequence.
 Halt on if Fail: When this function is enabled, the test process will halt if Fail occurs.
 Enable Backoff limit-4: The Backoff limit-4 function is for half-duplex mode only, and its
purpose is for collision control. Enabling this function will increase test performance and decrease
test fail rate.