Xtramus APMPT-4 V2.4 - Manual (Page 65)

65
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
packets with CRC error is higher than the amount you set here, the test fails. You can set the amount
by two ways: By Quantity and By Percentage .
 Enable Latency Check: enable the latency check function. There are two optional latency
calculation modes, namely Cut-Thought and Store-and-Forward. You can set the acceptable
latency in the red rectangle field, shown as the picture down below. If the latency exceeds the value
you set here, the test will fail. And this function is unavailable when the Frame Length is set to be
random.
 Enable line Rate Check: enable the line rate check function. You can set the lowest line rate in the
red rectangle field, shown as the picture down below. If the line rate is lower than the value you set
here, the test will fail.