Xtramus APMPT-4 V2.4 - Manual (Page 21)

21
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
Please follow the steps down below to start APMPT-4:
When starting APMPT- 4, a “Connect to NuServer”
window will pop up and asked how you are going to
connect to NuServer.
 Local Host: Choose this option when you‟re
running APMPT-4 from NuStreams-2000i IPC
module
or a PC that‟s connected to
NuStreams-2000i/600i via an RJ45 cable.

Remote:
Choose this option when you‟re running
APMPT-4 from other PC located on the network.
Choose the IP address which is assigned from
NuStreams-2000i/600i from the scroll-down menu。
 Demo: Choose demo to enter APMPT- 4‟s Demo
Mode.

Connect/Cancel: Click the Connect button to
connect to NuStreams-2000i/600i or click the
Cancel button to quit.
If NuServer is not running while starting APMPT-4, a
window will pop up and ask if you would like to run
NuServer. Please click Yes to continue or No to cancel.
A “NuServer-NIC Information” window will pop up. Please select the NIC (Network Interface Card) which is
connected to NuStreams -2000i/ 600i from the Network Interface Information t able, and click OK. If you‟re
using NuStreams-
2000i‟s IPC module, please choose “Realtek RTL8139 Family Fast Ethernet”. NuServer
will connect to the daughter boards, and APMPT-4 will start as well.