Xtramus APMPT-4 V2.4 - Manual (Page 122)

122
E-mail: [email protected]
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
To assign Active Ports as the Member Ports for Root 1, please click the Active Ports you would like to
use as Member Ports, and then click the  button to add it to the member Ports field located on the right
side. To remove a Member Port you‟ve assigned, click the Member Port you would like to remove, and
then click the  button.

Available Ports: All available Active
Ports will be shown in this field. If you
assign an Active Port as the Root Port or
one of the Member Ports, it will be
removed from this field.
 /: You can add an selected Active
Port as the Root Port or one of the
Member Ports by clicking the  button,
or remove the Root Port or Member
Ports by clicking the  button.
 Reset: Click this button to remove all
Active Ports that has been assigned as Root Port or Member Ports.
 Enable Root 1/2: Click these check boxes to select which Root you would like to use for 1 to
Many-UC test.
 Root 1/Root2: Click these tabs to choose which Root you would like to view/configure.