Adept s350 Cobra - Manual (Page 13)

Chapter 1: Introduction
CAUTION: This indicates a situation which, if not
avoided, could result in damage to the equipment.
NOTE: Notes provide supplementary information, emphasize a point or procedure,
or give a tip for easier operation.
1.3 Intended Use of the Robot
The Cobra s350 robot is intended for use in parts assembly and material handling for
payloads up to 2.0 kg. See Technical Specifications on page 79 for complete specifications.
Refer to the
Adept Robot Safety Guide for details on the intended use of Adept robots.
1.4 Safety Precautions
DANGER: An Adept Cobra s350 robot can cause serious
injury or death, or damage to itself and other equipment,
if the following safety precautions are not observed:
l
All personnel who install, operate, teach, program, or maintain the system must read
this guide, read the
Adept Robot Safety Guide , and complete a training course for their
responsibilities in regard to the robot.
l All personnel who design the robot system must read this guide, read the Adept Robot
Safety Guide , and must comply with all local and national safety regulations for the
location in which the robot is installed.
l The robot system must not be used for purposes other than described in Section 1.3.
Contact Adept if you are not sure of the suitability for your application.
l
The user is responsible for providing safety barriers around the robot to prevent anyone
from accidentally coming into contact with the robot when it is in motion.
l
Power to the robot and its power supply must be locked out and tagged out before any
maintenance is performed.
1.5 What to Do in an Emergency Situation
Press any E-Stop button (a red push-button on a yellow background/field) and then follow the
internal procedures of your company or organization for an emergency situation. If a fire
occurs, use CO
2
to extinguish the fire.
1.6 Additional Safety Information
Adept provides other sources for more safety information:
Adept Cobra s350 User's Guide, Rev. D
Page 13 of 94