Comtech EF Data SDM-100A - Manual (Page 165)

SDM-100A Satellite Modem Remote Control Operation
Rev. 0 A–13
AUPC
Minimum
Power Limit Command:
Response:
Status:
Response:
<add/MINP_snn.n'cr'
>add/MINP_snn.n'cr''lf']
<add/MINP_'cr'
>add/MINP_snn.n'cr''lf']
Where: snn.n = -30.0 to -5.0, in 0.1 steps (nominal range in
dBm).
Note: The nominal power range is modified relative to the value
specified by the modulator power offset (MPO_).
AUPC E
b
/N
0
Target Set
Point
Command:
Response:
Status:
Response:
<add/ENSP_nn.n'cr'
>add/ENSP_nn.n'cr''lf']
<add/ENSP_'cr'
>add/ENSP_nn.n'cr''lf'] Where: nn.n = 3.2 to 16.0, in 0.1 increments (E
b
/N
0
in dB).
AUPC
Maximum
Tracking
Rate Command:
Response:
Status:
Response: <add/MAXT_n.n'cr'
>add/MAXT_n.n'cr''lf']
<add/MAXT_'cr'
>add/MAXT_n.n'cr''lf']
Where: n.n = 0.5 to 6.0, in 0.5 increments (max. tracking rate in
dBm/minute).
AUPC Local
Carrier Loss
Action Command:
Response:
Status:
Response:
<add/LCL_xxxx'cr'
>add/LCL_xxxx'cr''lf']
<add/LCL_'cr'
>add/LCL_xxxx'cr''lf'] Where: xxxx = HOLD, NOM, or MAX (power level setting when
local carrier loss).
AUPC
Remote
Carrier Loss
Action Command:
Response:
Status:
Response:
<add/RCL_xxxx'cr'
>add/RCL_xxxx'cr''lf']
<add/RCL_'cr'
>add/RCL_xxxx'cr''lf'] Where: xxxx = HOLD, NOM, or MAX (power level setting when
remote carrier loss).
Remote
Modem
AUPC
Commands Notes:
1. Always wait 3 seconds between consecutive remote
modem command/status polls.
2. If Local AUPC is not enabled, status commands will
return last known condition. They will also request
status from the remote modem. This allows a second
request to return proper status.
Remote
AUPC
Enable Command:
Response:
Status:
Response: <add/RPC_xxx'cr'
>add/RPC_xxx'cr''lf']
<add/RPC_'cr'
>add/RPC_xxx'cr''lf']
Where: xxx = ON, OFF, or UNK (remote AUPC enable).
Remote
Interface
Baseband
Loop Back Command:
Response:
Status:
Response: <add/RBBL_xxx'cr'
>add/RBBL_xxx'cr''lf']
<add/RBBL_'cr'
>add/RBBL_xxx'cr''lf']
Where: xxx = ON, OFF, or UNK (remote baseband loop back
enable).