Comtech EF Data SDM-100A - Manual (Page 168)

Remote Control Operation SDM-100A Satellite Modem
A–16 Rev. 0
Demodulato
r Config
Status Command:
Response: <add/DCS_'cr'
>add/DCS_'cr'
DF_nnn.nnnn'cr'
DR_nnnn_mmm.mmm'cr'
ADRA_nnnn_mmm.mmm'cr'
ADRB_nnnn_mmm.mmm'cr'
ADRC_nnnn_mmm.mmm'cr'
ADRD_nnnn_mmm.mmm'cr'
ADRV_nnnn.mmm.mmm'cr'
DE_xxx'cr'
DDEC_xxx'cr'
RFL_xxx'cr'
IFL_xxx'cr'
SCF_snnnnn'cr'
SWR_nnnnn'cr'
BERT_xxxx'cr'
DT_xxxx'cr'
DDT_xxx'cr'
RDA_xxx'cr'
DSR_xxx'cr'
RSDE_xxx'cr''lf']
Demodulator Frequency
Demodulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Preset 'V' Assignment
Descrambler Enable (ON/OFF)
Differential Decoder (ON/OFF)
RF Loopback (ON/OFF)
IF Loopback (ON/OFF)
Sweep Center Frequency
Sweep Width Range
BER Threshold
Demodulator Type
Demodulator Decoder Type
Receive BPSK Data Ordering
Demodulator Spectrum Rotation
Reed-Solomon Decoder
The demodulator configuration status command causes a
block of data to be returned by the addressed modem. The
block of data reflects the current configuration of the demod.