Daktronics All Sport 5000 Series Operation Manual - Manual (Page 209)

Event Counter 191
Increment Value
Display Action
NNNN = current value
Press <INCREMENT VALUE •> to set the increment value.
The increment value will be added to the total value after each
time interval.
Decrement Value
Display Action
NNNN = current value
Press <DECREMEN T VALUE •> to set the decrement value.
The decrement value will be subtracted from the total value
each time interval if the increment value is 0.
Time Interval
Display Action
HH:MM.SS = hours, minutes,
seconds
Press <TIME INTERVAL •> to set the interval time between
each increment or decrement.
Note: The clock must be stopped to set the time interval.
When <START> is pressed to start the main clock, the controller counts down the time
interval to 00:00:00 and adjusts the initial value by the increment or decrement value. The
interval time resets and the cycle will repeat until <STOP> is pressed.
15.4 External Input Counting Codes
The External Input Counter counts the occurrences of external switch inputs starting at the
initial value.
Display Action
NNNNNNN = current value
The current value is shown on the top line of the LCD.
I NCREMENT VALUE
NNNN*
DECREMENT VALUE
NNNN*
I NTERVAL
HH:MM:SS*
VALUE = NNNNNNNN
EXT I NPUT MODE