JB-Lighting Licon 1X - Manual (Page 15)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 15 -
The individual softkeys have the following function:
SCAN 1:
enters DMX addresses for fixture no. 1 – 16
SCAN 2: enters DMX addresses for fiixture no. 17-32
AUX: enters DMX addresses for AUX controllers
PAR1: enters DMX addresses for dimmer channel 1-16
PAR2: enters DMX addresses for dimmer channel 17-32
PAR3: enters DMX addresses for dimmer channel 33-48
PAR4: enters DMX addresses for dimmer channel 49-64
PAR5: enters DMX addresses for dimmer channel 64-80
PAR6: enters DMX addresses for dimmer channel 81-96
A/B: selects the DMX output
CLEAR: deletes all DMX addresses
OPEN: deletes an individual DMX address
PATCH: confirms data input
Left encoder wheel: selects DMX addresses
Middle encoder wheel: moves the cursor up and down
Right encoder wheel: moves the cursor to the left and right
2.3.1 Entering DMX start addresses for fixtures
Press the softkey PATCH. The first fixture in the fixture list is automatically activated and start address
no. 1 or the first not occupied DMX address is recommended by the controller for the patch (DMX
channels cannot be double-assigned). If you wish to control fixture no. 1 with DMX channel 1, DMX line
A, then confirm by pressing the softkey PATCH. Now the second fixture of the list is displayed inverted
and the controller automatically recommends the next not occupied channel for the patch. (The example
above recommends DMX channel 9, since the Varyscan 4 is controlled with 8 DMX channels.) Press the
softkey PATCH again to confirm this start address. If you need a start address other than that
recommended by the controller, select the desired start address with the left encoder wheel and press the
softkey PATCH for confirmation.
Select the fixtures with the middle encoder wheel.
Press the softkey A/B to determine the DMX line of the fixtures.
 Press the ESC key to leave this menu.
2.3.2 Deleting a particular start address
To delete a particular start address, press the softkey CONFIG/PATCH to enter the Patch menu. Select
the corresponding fixture with the centre encoder wheel. As soon as the fixture is displayed inverted,
press the softkey OPEN to delete the start address.
 Press the ESC key to leave this menu.
2.3.3 Deleting all start addresses
If you wish to delete all start addresses, enter CONFIG/PATCH menu and press the softkey CLEAR. The
following selection appears on the display:
ALL:
deletes all DMX start addresses
SCAN: deletes start addresses of moving lights
AUX: deletes start addresses of AUX controllers
PAR: deletes DMX assignment of dimmer/PAR channels
After you have pressed one of the the softkeys ALL, SCAN, AUX or PAR, the corresponding parameters
are deleted without prior confirmation prompt. Press the ESC key if you do not wish to delete a start
address.
 Press the ESC key to leave this menu.