JB-Lighting Licon 1X - Manual (Page 92)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 92 -
18.8 Storing presets (PRESET)
In the PAR section, as in the Fixture section, you can store presets. PAR presets must always be
stored in the Combi section.
Enter the main menu and press the softkey PRESET. Select one of the PAR keys (1-32) (PAR 33-64,
PAR 65-96) in the Feature Selection section and enter the DMX values for the
desired PAR channels.
Press the Store key in the Combi section (the Store LED is lit) and press the
corresponding softkey to select the desired storage place on the display (the
Store LED is flashing).
When the Preset field is displayed inverted,
you can name the Preset with the double-
assigned keys of the Cues, Chases and
Sequences sections.
When presets of the PAR section are stored,
not all channels are activated automatically, as
is the case in the Fixture section. Here, only
those channels are stored in a Preset that
have been activated previously (at least one
LED in the Fixture/PAR selection section must be lit).
Press the Store key in the Combi section again to execute the process.
18.8.1 Recalling PAR presets
Press one of the PAR keys in the Fixture Selection block. Activate the ENCODE function. Then press the
corresponding softkey to recall the desired presets.
18.8.2 Fading PAR presets
Press one of the PAR keys in the Feature Selection block.The stored Presets will be
shown on the display and can be recalled with the corresponding softkeys. The fading
time of PAR presets is controlled with the Preset-Fade fader in the Feature Selection
block. Select a fade time between 0.0 to 10 seconds.