JB-Lighting Licon 1X - Manual (Page 70)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 70 -
In the Edit Combi Chase menu, the function SGROUP is displayed. Press and hold the softkey SGROUP.
Simultaneously press one of the speedgroup keys in the Cue section, to which you want to assign the
chase.
The assignment is shown in the menu on the display.
In the middle of the display, the name of the speedgroup is shown,
to which the chase has been assigned (here: speedgroup 1 (G1)).
Simultaneously, another function, the synchronised start function
(SYNCST) appears on the display.
The speed of the chase can be changed with the keys and the
encoder wheels of the Chase Control section.
 Chapter 13
12.2.2 Deactivating a speedgroup
If you wish to remove a chase from a speedgroup, proceed as follows:
Press the Edit key in the Combi section and recall the desired chase by pressing the corresponding
chase key. Then press the softkey SGROUP. The assignment is deleted immediately. You will see, that
instead of the name of the speedgroup, the speed is specified in seconds. In addition, the function
SYNCST disappears from the display.
12.2.3 The synchronised start function (SYNCST)
All chases of a speed group, to which the Synchronised Start function was assigned, will start
synchronously, when one chase of the group is activated.
The illustration below shall explain the principle of the Synchronised Start function.
The Synchronised Start function has the
same visual effect as the MERGE function,
although they are managed differently by the
lighting control console. Whereas the MERGE
function is a fixed connection between two or
more chases, which cannot be dissolved so
easily, you can delete the Synchronised Start
function with only one keystroke.