JB-Lighting Licon 1X - Manual (Page 31)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 31 -
3.4 Entering fixture parameters with the encoder wheels
Fixture parameters can only be entered, when the desired fixtures have been activated before by
pressing the corresponding keys in the Fixture-/PAR Selection (LEDs must be lit).
After that you have access to the individual features (e.g. PAN/TILT or gobo). Activate these features by
pressing the corresponding keys in Feature Selection and enter the values with the encoder wheels.
Caution:
The Licon 1X controls the brightness values separately.
For visual control of the entered parameters, raise the corresponding brightness faders. Then proceed as
described in chapters 3.2.1 and 3.2.2 Storing and activating fixture groups, which means that you have to
define the fixture groups first in order to gain access to the brightness faders.
3.4.1 Positioning fixtures with 16 Bit
Rough positioning of the fixtures is carried out with 8 bit. The display shows this in steps from 0 to 255.
For a more precise positioning of the fixtures, the fine adjustment is carried out in the 16 bit range. (This
is only possible, when the Pan/Tilt parameters of the fixture can be controlled by the Licon 1X with 16 bit
and when this feature was entered during the configuration of the fixture and the Licon 1X.)
You can switch between the 8 bit and 16 bit range with the middle encoder wheel (FINE OFF). The
display will then show values between 000 and 65535.