JB-Lighting Licon 1X - Manual (Page 66)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 66 -
An empty square „ “ stands for an OFF value and a black square „“
for an ON value. The ON and OFF values are entered on page 1 of
the chase generator.
A chase switches between the ON and OFF value according to the sequence entered in the matrix of the
chase generator.
The matrix displayed her can be decoded as follows:
Example:
The chase addresses 6 fixtures.
ON value: shutter is open.
OFF value: shutter is closed.
In the first chase step, the shutter of fixture 1 is open, whereas the shutter of
the other five fixtures is closed.
In the second chase step, the shutters of fixtures 1, 3, 4, 5 and 6 are closed,
whereas the shutter of fixture 2 is open.
In the third chase step, the shutters of fixtures 1, 2, 4, 5 and 6 are closed,
whereas the shutter of fixture 3 is open, etc.
If a pattern is marked with two arrows, it will run to the end (last step) and back to the first
step again. Patterns not marked with arrows will always run as loop from the first to the
last step.
When you have selected the number and sequence of the desired
fixtures or dimmers, press the corresponding softkey to select the
desired chase pattern. The display will immediately show the number
and the sequence of the chase steps.
After the designation VALUES the number of steps is specified in
brackets. In addition, the DMX values of each step are listed (below
the designation VALUES).
To enter the individual chase parameters press the softkeys „<<<“ or
„>>>“ to switch to page 5.
Press the Store key in the Combi section to confirm and store the data. The display returns to the PROG
COMB CHASE menu.