JB-Lighting Licon 1X - Manual (Page 27)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 27 -
2.12.2 Entering the user passwords
After activation of the master password, access is given to
the user profiles. They can be activated by means of the
middle encoder wheel. You can choose between four user
profiles. Select the user profile, for which you want to enter
the acess rights.
Example on the left: USER 1
USER 1 is a DJ. He shall have no access to the
configuration and the storage of presets.
First enter the user password. Then activate the password
by pressing the sofkey STATUS. The fourth line on the left
shows, whether the status is INACTIVE or ACTIVE.
Then you can define the individual access rights. For the access to the CONFIG and Preset menu, you
can choose between the possibilities full (full access) or denied (access denied).
Since a DJ normally does not need to change configurations or presets, enter DENIED. The entry is
made with the softkey of the corresponding item on the right side of the display. Thus press the softkey
CONFIG, until „denied“ will appear on the display.
Enter the access rights for presets as is described for CONFIG.
For the access to the store function, you have the choice between the following three access levels: full,
denied and limited access.
Press the softkey STORE until „limited“ appears on the display. With this limited access your user has the
right to store own cues on Page 3 or Bank D (this section is located next to the cues and chase keys).
This user has access only to Page 4 in the SEQUENCES section and to faders in the Fixture-/PAR
selection.
 Press the ESC key to leave the menu.
2.12.3 Checking passwords
As soon as the Licon 1X is switched on, the password prompt appears on the display (when activated in
the access menu).
Enter the password and confirm with the softkey OK.
The master password gives access to all parameters of the lighting control console. The user passwords
1 – 4 will only activate those parameters that are defined in the ACCESS menu as „full“ or „limited“.
If you have forgotten the master password, please contact your local JB-lighting dealer and ask for the
main password.
2.12.4 Changing passwords
Passwords are entered and changed in the CONFIG menu. You have access to the CONFIG menu after
you have entered the master password or a user password. However, access rights to the CONFIG must
previously be given to this user in the ACCESS menu. Change the passwords in the CONFIG menu as
described in chapter 2.12.1 and 2.12.2.