JB-Lighting Licon 1X - Manual (Page 85)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 85 -
17.2.1 Changing the speed of sequences
Man-Fade key:
Red LED: displays current status, sequences can only be faded manually with the Time/Man fader.
Green LED: no function.
Go key:
Red LED: displays current status,sequences can be switched manually with the GO- or GO+ keys.
Green LED: no function.
Sound key:
Red LED: displays current status.
Green LED: indicates the beat count connected to the sound input on the rear panel of the Licon 1X.
Rate key:
Red LED: displays current status, this key overwrites the NextTime of sequences.
Yellow LED: indicates the speed of the rate fader.
Time key:
Red LED: displays current status, the fade time of sequences are overwritten by the time entered with the
fader.
Rate fader:
The rate fader addresses the NextTime of sequence steps. As soon as the red LED of the rate key is lit,
the NextTime of the sequence steps can be overwritten manually with the fader.
Time/Man fader:
The Time/Man fader addresses the fade times of sequence steps.
Time/Man fader in combination with the Man-Fade key:
Enables manual fading of sequence steps. The time, in which the fader is raised from 0 to 10 indicates
the fade time. As soon as the fader is on position 0 or on position 10, the next sequence step will be
activated.
Time/Man fader in combination with the time key:
Activates time scaling of the Time/Man fader. The fade time can be set between 0 and 10 seconds (steps
as shown on the scale).
17.3 The ENABLE key
If the priority of fixtures is taken from an active sequence, e.g. by a preset, cue or chase, these priorities
can be returned without having to start the sequence anew. This function has no effect in the Follow and
Freeze function (see Chapters 9 and 10).
Press the key combination of Enable + key of active sequence.
+