JB-Lighting Licon 1X - Manual (Page 24)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 24 -
2.11.1.1 Mode of operation of the swap function
The swap function sets to zero the output values of all fixture and PAR faders, with the exception of those
faders, the flash keys of which are pressed in combination with the swap key.
2.11.1.2 Working with the swap function
Brightness output in the Fixture-/ PAR Selection is
controlled with the corresponding faders. If the swap
key is pressed simultaneously with the flash key
located below a fader, then the brightness output of all
other faders is set to zero. Only the values of those
fader(s) with activated flash keys will be output. Depending on the
CONFIG settings, the swap function accesses the PAR faders, the
fixture faders or both fader banks.
2.11.2 Displaying DMX values in percent
The DMX values of the Licon 1X can be entered as values from 000 to 255 or in percent from 000 to 100.
This selection can be made independently of the entry of PAR or fixture values.
2.11.2.1 Activating the percent function
Enter the CONFIG/OPTION menu by pressing the corresponding sofkteys.
The following display is shown:
To activate the percent function, press the softkey FIXT %
or/and PAR %.
The activated function is displayed as shown on the left.
In addition, a percentage sign is displayed:
To deactivate the percent function, repeat the procedure. The deactivation was successful, when the
function field is no longer displayed inverted.
2.11.3 CHCTRL / Setting the Chase Control Section
If the CHCTRL function is not activated (displayed: CHASE CONTROL : MANUAL SEL), the chase
selected last in the COMBI section can be controlled via the Chase Control Section.
If the CHCTRL function is activated (displayed inverted: CHASE CONTROL : MANUAL SEL), a chase
selected by the key combination Select + Chase key can be controlled via the Chase Control Section.
This function applies to the Combi section, since in the PAR section chases are on principle activated by
the key combination Select + Chase key.