JB-Lighting Licon 1X - Manual (Page 44)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 44 -
7. Editing cues
All functions and parameters of a cue can be modified separately. You are not required to rewrite the
whole cue.
On principle, the followng working steps are necessary for editing cues:
Enter the Edit menu by pressing the Edit key (LED is lit) in the Combi section.
Select the desired cue by pressing the corresponding cue key and press the
softkey MODIFY. You can now edit the individual parameters.
In order to store the modifications, press the Store key in the Combi section
and the storage matrix appears. Carry out your modifications as planned in the
storage matrix. Press the Store key again to confirm the modifications. Press the Edit key again or the
ESC key to leave the Edit menu.
Activate a cue with the Edit key in the Combi section and the following display appears:
The illustration shown on the left indicates, if parameters are
stored in this cue or not.
Stored parameters:
No parameters stored (storage matrix is empty):
You have no direct access to the following cue parameters: name, fade time, trigpoint and release link.
Press the softkey MODIFY and you can modify all other cue values.
7.1 The FLASH function
The flash function can only be set in combination with a release link and an additional cue. When a flash
function was assigned to a cue, the cue key no longer works as switch-key, but as flash key.
To activate the flash function, press the softkey FLASH. The field on the display is shown inverted.
Simultaneously press the softkey R-LINK and the cue key, on which the Off-Cue was stored. Cf.: 6.1.7
Entering the release link function and 6.1.8 Working with the release link.