Yaskawa Sigma-5 User Manual: Setup for Rotary Motors - Manual (Page 64)

3 Wiring and Connection
3.2.1 Connecting to SGDV-††††01† SERVOPACK (Analog Pulse Model)
3-6
„ SGDV-†††D01A
∗1. Use a 24 VDC power supply with double insulation or reinforced insulation. (The power
supply is not included)
∗2. Before connecting an external regenerative resistor to the SERVOPACK, refer to 3.4 Con-
necting Regenerative Resistors.
∗3. Use a following power supply for 90 V brake. For details, refer to Σ -V series Product Cat-
alog (KAEP S800000 42).
• For 200 V input voltage: LPSE-2H01-E
• For 100 V input voltage: LPDE-1H01-E
*1
R S T
100/200 VAC
DC power
supply (24 V)
SGMGV/SGMSV
Servomotor
SGDV- D01A
SERVOPACK
Power supply
Three-phase 400 VAC
Noise filter
Molded-case
circuit breaker
(MCCB)
Protects the power supply
line by shutting the
circuit OFF when
overcurrent is
detected.
Used to eliminate
external noise from
the power line.
Magnetic
contactor
Turns the servo
ON and OFF.
Install a surge
absorber.
Brake power
supply* 3
Used for a
servomotor
with a 90 V brake.
Turns the brake power
supply
ON and OFF.
Install a surge absorber.
Motor main
circuit cable
Encoder cable
When not using the safety
function, use the SERVOPACK
with the safety function jumper
connector (JZSP-CVH05-E,
provided as an accessory)
inserted.
When using the safety function,
insert a connection cable
specifically for the safety function.
Safety function
devices
I/O signal cable
Connection cable
for digital operator
Connection cable
for personal computer
Digital
operator
Personal
computer
Host controller
Regenerative
resistor* 2
Battery case
(when an absolute
encoder is used.)
Magnetic contactor