Yaskawa Sigma-5 User Manual: Setup for Rotary Motors - Manual (Page 9)

ix
„ Storage and Transportation
• Provide an appropriate braking device on the machine side to ensure
safety. The holding brake on a servomotor with a brake is not a braking
device for ensuring safety.
Failure to observe this warning may result in injury.
• Do not come close to the machine immediately after resetting a momentary
power loss. The machine may restart unexpectedly. Take appropriate mea-
sures to ensure safety against an unexpected restart.
Failure to observe this warning may result in injury.
• Connect the ground terminal according to local electrical codes (100 Ω or
less for a SERVOPACK with a 100, 200 V power supply. 10 Ω or less for a
SERVOPACK with a 400 V power supply.)
Improper grounding may result in electric shock or fire.
• Installation, disassembly, or repair must be performed only by authorized
personnel.
Failure to observe this warning may result in electric shock or injury.
• The person who designs a system using the safety function (Hard Wire
Baseblock function) must have full knowledge of the related safety stan-
dards and full understanding of the instructions in Σ -V Series User’s Man-
ual Design and Maintenance (SIEP S800000 45/46/60/64).
Failure to observe this warning may result in injury or damage to the product.
WARNING
CAUTION
• Do not store or install the product in the following locations.
Failure to observe this caution may result in fire, electric shock, or damage to the
product.
• Locations subject to direct sunlight
• Locations subject to temperatures outside the range specified in the storage/
installation temperature conditions
• Locations subject to humidity outside the range specified in the storage/instal-
lation humidity conditions
• Locations subject to condensation as the result of extreme changes in tempera-
ture
• Locations subject to corrosive or flammable gases
• Locations subject to dust, salts, or iron dust
• Locations subject to exposure to water, oil, or chemicals
• Locations subject to shock or vibration
• Do not hold the product by the cables, motor shaft or detector while trans-
porting it.
Failure to observe this caution may result in injury or malfunction.
• Do not place any load exceeding the limit specified on the packing box.
Failure to observe this caution may result in injury or malfunction.