TA Triumph-Adler DC 2075 - Manual (Page 141)

Section 7 COPIER MANAGEMENT FUNCTIONS
7-3
(2) Accessing the copy management mode settings
Perform the following procedure when you want to access the
screens for each of the various copy management mode settings.
1 With the content of the “Basic” tab displayed, press the [ ]
key. The “Default setting” screen will be displayed.
2 Touch the “Management” key on the right side of the touch
panel.
Inch specifications
Default setting
Default setting
Copy
default Weekly
timer
Machine
default
Language Management
End
BOX
Management Bypass
setting
Document
Management Print
report
Metric specifications
Default setting
Default setting
Copy
default
Machine
default
Language
Bypass
setting
Management
Week
timer
End
Hard Disk
Management
Document
Management Print
report
3 Use the keypad to enter the 4-digit management code.
The factory default setting for 63 cpm copiers is “6300” and
for 75 cpm copiers is “7500”. If the entered code matched
the registered one, the “Management code menu” screen will
be displayed.
Inch specifications
Enter the administrator number Close
Metric specifications
Enter the administrator number Close
4 Touch the key that corresponds to the desired copy
management mode setting.
The screen for that setting will be displayed.
Inch specifications
Counter
by ID-code Print
the list
Management menu
Default setting
Management code menu
# of copy
clear
Counter
correct
ID-code
Reg./Del.
P r i n t e r c o py
Off
On
Close
Off
On Print
Err. PRT.
Metric specifications
Counter
by ID-code Print
the list
Management mode
Default setting
Management code menu
clear
counter
ID-code
Reg./Del.
P r i n t e r C o py
Off
On
Close
# of copy
correct
Off
On
Print
Err. PRT.
NOTES
• It is possible for you to change the 4-digit management code.
(See “Changing the management code” on page 7-34.)
• Refer to the desired procedure(s) explained under “(3) Making copy
management settings” and perform the corresponding setting(s).