TA Triumph-Adler DC 2075 - Manual (Page 153)

Section 7 COPIER MANAGEMENT FUNCTIONS
2. Weekly timer
Power to the copier can be turned ON and OFF automatically at specified times on each day of the week between Monday and Sunday.
Set the copier to be turned ON early so that it is warmed up and ready for the start of work in the morning, and set it to be turned OFF automatically
in the evening in case nobody remembers to switch it off manually.
NOTES
• When the weekly timer is turned ON, do NOT remove the power plug from its power source and be sure to leave the main switch ON ( | ) as well.
• In order to have the weekly timer operate properly, make absolutely certain that the settings for the date and time are correct.
(1) Settings for the weekly timer
Setting
● Programming the
weekly timer
● Canceling the timer
function temporarily
● Turning the weekly
timer ON/OFF
Description
Perform this procedure when you want to register the times at which the copier is to be
turned ON and OFF during each day of the week. If you leave the main switch ON ( | ),
the copier will be turned ON and OFF automatically at the times scheduled for each
individual day. You can also set the timer to leave the copier ON or OFF all day for any
day of the week.
It is possible to cancel the timer setting temporarily (only for the next time that day
comes) for any specified day.
Perform this procedure when the copier is to be out of use for any full day (holiday, etc.)
outside of the normal weekly schedule. In this case, it is necessary to cancel the timer
function in advance for the day in question. The copier will then remain OFF for that
whole day but, on the same day of the following week, the timer will resume turning the
copier ON and OFF at the times originally registered.
Perform this procedure when the weekly timer function is not required and you want to
turn it OFF.
Reference page
7-15
7-16
7-17
(2) Accessing the weekly timer settings
Perform the following procedure when you want to access the
screens for each of the weekly timer settings.
1 With the content of the “Basic” tab displayed, press the [ ]
key. The “Default setting” screen will be displayed.
2 Touch the “Weekly timer” [“Week timer”] key on the right side
of the touch panel.
Inch specifications
Default setting
Default setting
Copy
default Weekly
timer
Machine
default
Language Management
End
BOX
Management Bypass
setting
Document
Management Print
report
Metric specifications
Default setting
Default setting
Copy
default
Machine
default
Language
Bypass
setting
Management
Week
timer
End
Hard Disk
Management
Document
Management Print
report
7-14