TA Triumph-Adler DC 2075 - Manual (Page 233)

Section 9 TROUBLESHOOTING
9-3
Message
“Cannot staple. ___: maximum capacity
(Staple)”
[“Cannot staple. ___: Max. staples”]
“The output tray exceeds capacity.
Remove paper, and press “Start” key.”
[“Too much paper in output tray. Remove
paper, and press “Start” key.”]
“The output tray exceeds capacity.
Remove paper, and press “Continue”
key.”
[“Too much paper in output tray. Remove
paper, and press “Continue” key.”]
“Finisher paper capacity exceeded.
(Tray x) Remove paper, and press
“Start” key.”
“Finisher paper capacity exceeded.
(Tray x) Remove paper, and press
“Continue” key.”
“These functions cannot be combined.”
“Tandem Copy is cancelled. Unable to
Tandem Copy under current setting.”
[“Cancel tandem copy. Cannot tandem
copy with the present setting.”]
“Exceeds pre registered copying
quantity.”
[“Copy limit for this ID-code has been
reached. No copying possible.”]
“Insert key counter.”
“Memory full.”
“Memory full. Delete the registered data
in the box.”
[“Memory full. Delete the registered data
from box.”]
“Ready to copy.
Add toner.”
Procedure
The number of copies stapled in the optional Document Finisher has exceeded the
acceptable limit. For more detailed information, refer to the Operation Guide for your
Document Finisher.
The number of copies in the copy eject tray has exceeded the acceptable limit.
Remove the copies from the copy eject tray and then press the [Start] key.
When using the copier as a printer, the number of print outs in the copy eject tray
has exceeded the acceptable limit. Remove the print outs from the copy eject tray
and then touch the “Continue” key.
The number of copies in the designated tray of the optional Document Finisher has
exceeded the acceptable limit. Remove the copies from that tray and then press the
[Start] key.
When using the copier as a printer, the number of print outs in the designated tray of
the optional Document Finisher has exceeded the acceptable limit. Remove the print
outs from that tray and then touch the “Continue” key.
The function or mode that you just selected cannot be used in combination with the
currently set function or mode.
Tandem copying (option) is not possible. Touch the “Check” key and check the copy
settings.
The number of copies made under your department ID-code has reached the limit
that was set under the copy management mode and copying is no longer possible
with that code. Use the copy management mode to clear the copy count.
Insert the Key Counter securely into its opening.
The copier’s memory is full. Select whether you want to print out that data that is
already scanned or delete all of that data. It will not be possible to copy or scan
another original until one of these two operations is performed.
The memory for the document management function boxes is full. In order to register
new documents in any of the boxes, delete any unnecessary data.
There is insufficient toner left in the copier. Since only one copy can be made at a
time in this state, add toner as soon as possible.
Reference
page
——
——
——
——
——
——
——
7-8
8-7
——
6-1
3-9