TA Triumph-Adler DC 2075 - Manual (Page 97)

Section 5 OTHER CONVENIENT FUNCTIONS
5-51
25. Memorizing frequently used settings [Program function]
Up to eight combinations of copy modes and other functions
displayed on the operation panel can be registered as a single
program using this function. You can also register a name for each
registered program.
(1) Registering a program
1 Set the desired copy modes, etc., to be registered.
2 Touch the “Program” tab. The content of the “Program” tab
will be displayed.
3 Touch the “Register” key.
Inch specifications
Recall
Ready to copy.
Program Function
Reg./delete
Register
Change
name
Delete
User choice Basic
Set
11 x 8 1 / 2 "
Paper Size
Metric specifications
Reg./delete
Register
R e c a l l
Delete
Change
name
Basic User choice Function Program
Ready to copy. Set Paper size
4 Touch any key that is marked “No registration” and that
corresponds to the program key (1 – 8) under which you
want to register the settings. The screen to register a name
for that program will be displayed.
Inch specifications
Select program number.
No registration
No registration
No registration
No registration
No registration
No registration
No registration
Register present setting End
No registration
Metric specifications
Select program number.
No registration
No registration
No registration
No registration
No registration
No registration
No registration
Register present setting End
No registration
5 Use the displayed keyboard to enter the desired name and
then touch the “End” key.
Inch specifications
Metric specifications
NOTE
Refer to “Entering characters” on page 7-79 for information on
entering characters.
6 Touch the “Yes” key or the “No” key, as appropriate.
If you selected “Yes”, the selected program will be registered
and the touch panel will return to the screen in step 3.
Copying is now possible using the settings that were
registered under that program.
Inch specifications
Program # : 1
The set program is registered. Is it correct?
Yes No
Program name :Catalog A
Register program. Stop
Metric specifications
Program # : 1
The set program is registered. Is it correct?
Yes No
Program name : Catalog A
Register program. Stop