TA Triumph-Adler P-4030i MFP User Manual
Page 360
10-12
Troubleshooting > Troubleshooting
2 or more sheets are
overlaps when ejected.
(multi feed)
―
Load the paper correctly.
Printouts are wrinkled.
Is the paper loaded correctly?
Load the paper correctly.
Is the paper damp?
Replace the paper with new paper.
Printouts are curled.
Is the paper damp?
Replace the paper with new paper.
Cannot print.
Is the machine plugged in?
Plug the power cord into an AC outlet.
―
Is the machine powered on?
Turn on the power switch.
Are the printer cable and network cable
connected?
Connect the correct printer cable and
network cable securely.
Was the machine powered on before the
printer cable was connected?
Power on the machine after connecting
the printer cable.
―
Is the print job paused?
Resume printing.
Cannot print with USB
memory.
USB memory not
recognized.
Is the USB host blocked?
Select [Unblock] in the USB host
settings.
―
Check that the USB memory is securely
plugged into the machine.
―
Dirt on the top edge or back
of the paper.
Is the interior of the machine dirty?
Clean the interior of the machine.
Part of the image is
periodically faint or shows
white lines.
―
Press the [
System Menu/Counter
] key,
[Adjustment/Maintenance], [Service
Setting], [MC] and decrease the
adjustment value. Decrease the
adjustment value 1 level at a time from
the current value. If there is no
improvement after the value is
decreased by 1 level, decrease by 1
level again. If there is still no
improvement, return the setting to the
original value.
―
―
Run [Drum Refresh].
Symptom
Checkpoints
Corrective Actions
Reference
Page