TA Triumph-Adler P-4030i MFP - Manual (Page 59)

2-15
Installing and Setting up the Machine > Energy Saver function
Sleep and Auto Sleep
Sleep
To enter Sleep, press the [ Energy Saver ] key. Touch panel and all indicators on the operation panel will go out to save a
maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing.
To resume, perform the following actions.
• Press the [ Energy Saver ] key.
The machine will be ready to operate within 15 seconds (P-4030i MFP/P-4035i MFP), 20 seconds (P-5035i MFP) or 25
seconds (P-6035i MFP).
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time in the Low Power Mode.
The default preset time is 1 minute.
To change the preset sleep time, refer to Quick Setup Wizard on page 2-17 .
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card cannot
be recognized.
For more information on Sleep Rules settings, refer to Sleep Rules (models for Europe) on page 8-38 .
NOTE
If the Low Power Timer is equal to the Sleep Timer, a Sleep mode is preceded.
Energy Saver indicator