TA Triumph-Adler P-4030i MFP - Manual (Page 55)

2-11
Installing and Setting up the Machine > Default Settings of the Machine
Default Settings of the Machine
Before using this machine, configure such settings as date and time, network configuration, and energy saving functions
as needed. The Machine Setup Wizard is launched when the equipment is turned on for the first time after being
installed. Also, configure the following settings if necessary.
Setting Date and Time
Follow the steps below to set the local date and time at the place of installation.
When you send an E-mail using the transmission function, the date and time as set here will be printed in the header of
the E-mail message. Set the date, time and time difference from GMT of the region where the machine is used.
1 Display the screen.
Press the [ System Menu/Counter ] key, [ ], and then [Date/Timer/Energy Saver].
2 Configure the settings.
1 Set the time zone.
NOTE
The default settings of the machine can be changed in System Menu. For settings that are configurable from System
Menu, refer to
Setup and Registration (System Menu) (page 8-1) .
NOTE
To make changes after this initial configuration, refer to Date/Timer/Energy Saver on page 8-37 and System/Network
on page 8-27 .
1
System Menu/Counter.
System Menu
Printer
10:10
System/Network
Date/Timer/Energy Saver
5/5
Close
Adjustment/Maintenance
3
2
System Menu/Counter.
Date/Timer/Energy Saver
Date/Time
10/10/2013 10:10
10:10
Date Format
DD/MM/YY
On
+09:00 Osaka, Sapporo, Tokyo
Time Zone
Auto Panel Reset
1/4
< Back
System Menu/Counter.
Date/Timer/Energy Saver - Time Zone
-12:00 International Date Line West
10:10
+13:00 Samoa
-11:00 Universal Coordinated Time-11
-10:00 Hawaii
1/24
Cancel OK
1
2