PLANET HDVR-1600 - Manual (Page 33)

Step 2 : Setup the <Alert Notification Setup> on the connected DVR(s). The <Alert Notification Setup>
allows the user to send alert notifications to the HCMS program which had been installed to the
computer.
Alert Notification Setup
1. Alert Configuration Set 1
2. Alert Notification OFF
3. Alert IP 192.168.7.122
4. Alert Port 9999
5. Alive Interval 120sec
- Alert Configuration Set
<Alert Configuration Set> provides 3 combinations of Alert Notification, IP, and Port. The user
can match the connected DVR to at most 3 different HCMS servers.
- Alert Notification
4 options are included in this item; <OFF>, <Event>, <Alive>, and <Both>.
<OFF>: The Alert Notification is turned off.
<Event>: When the alarm is triggered, the DVR will send an alert message to the HCMS.
<Alive>: The DVR will send an alive message to the HCMS every N second just to show
that the connection between the DVR and HCMS is in effect. The time interval N
can be adjusted in <Alive Interval>.
<Both>: This enables the DVR to send both Event and Alive alert messages to the HCMS.
- Alert IP
The Alert IP must match the IP address of the local computer. In this example, the IP address
of the local computer is 192.168.7.122.
- Alert Port
The Alert Port is the port used for sending and receiving alert signals. Choose any port that is
not restricted by the network. The ports for both connected DVR and the HCMS Alert must
be the same . In this example, the port is set to 9999.
- 33 -