ProSoft Technology 5201-MNET-101S - Manual (Page 134)

IEC 60870-5-101 Slave Interoperability Statement IEC-101 Slave ♦ ProLinx Communication Gateway
Protocol Manual IEC 60870-5-101 v3 Slave (Firmware version 3.xx)
Page 134 of 159 ProSoft Technology, Inc.
August 6, 2010
6.6.3 System Information in Monitor Direction
(Station-specific parameter; mark " X" if used)
 <70> := End of initialization M_EI_NA_1
6.6.4 System Information in Control Direction
(Station-specific parameter; mark each Type ID " X" if it is only used in the
standard direction, " R" if only used in the reverse direction, and "B" if used in
both directions)

<100> := Interrogation command C_IC_NA_1
 <101> := Counter interrogation command C_CI_NA_1
 <102> := Read command C_RD_NA_1
 <103> := Clock synchronization command C_CS_NA_1
 <104> := Test command C_TS_NB_1
 <105> := Reset process command C_RP_NC_1
 <106> := Delay acquisition command Note 1 C_CD_NA_1
6.6.5 Parameter in Control Direction
(Station-specific parameter; mark each Type ID " X" if it is only used in the
standard direction, " R" if only used in the reverse direction, and "B" if used in
both directions)

<110> := Parameter of measured, normalized value P_ME_NA_1
 <111> := Parameter of measured, scaled value P_ME_NB_1
 <112> := Parameter of measured, short floating-point
value P_ME_NC_1
 <113> := Parameter activation P_AC_NA_1
6.6.6 File Transfer
(Station-specific parameter; mark each Type ID " X" if it is only used in the
standard direction, " R" if only used in the reverse direction, and "B" if used in
both directions)

<120> := File ready F_FR_NA_1
 <121> := Section ready F_SR_NA_1
 <122> := Call directory, select file, call file, call section F_SC_NA_1
 <123> := Last section, last segment F_LS_NA_1
 <124> := Ack file, ack section F_AF_NA_1
 <125> := Segment F_SG_NA_1
 <126> := Directory F_DR_TA_1