ProSoft Technology 5201-MNET-101S - Manual (Page 159)

IEC-101 Slave ♦ ProLinx Communication Gateway Index
IEC 60870-5-101 v3 Slave (Firmware version 3.xx) Protocol Manual
ProSoft Technology, Inc. Page 159 of 159
August 6, 2010
RTS On • 36
S
Scan Events • 34
Select/Operate Timeout • 26
Selection of Standard ASDUs • 132
Sequence Flag • 40
Serial Port Cable Connections
Config/Debug and Port 0 • 51
Set Priority Queues • 30
Set Time Command Block • 125
Setting Up the Project • 13
Short Pulse Time • 38
Single char ACK C1 or C2 • 27
Single char ACK F0, 1 or 3 • 26
Slave Driver • 68
Slave Error and Status • 128
Spontaneous Transmission • 137
Start Here • 9, 11
Station Initialization • 137
Station Interrogation • 138
Status Data Area • 65
Support, Service & Warranty • 9, 149
Swap Code • 18
System Information in Control Direction • 134
System Information in Monitor Direction • 134
System or Device • 130
T
Test Procedure • 140
Time DB Offset • 24
Time Information • 106
Time Limit for Bringing Suit • 155
Time Type • 35
To Address • 18
To order a ProLinx Plus gateway with the -WEB option
• 3
To upgrade a previously purchased Series C model: •
3
Transmission Mode for Application Data • 131
Transmission of Integrated Totals • 139
Transmission Speed (Control Direction) • 130
Transmission Speed (Monitor Direction) • 130
Type Identifier and Cause of Transmission
Assignments • 135
U
Unbalanced mode • 78
Use ACTTERM with Set Point • 26
Use ACTTERM with Step • 26
Use Balanced Mode • 35
Using Control (Command) Points • 88
Using Monitor Points • 81
Using ProSoft Configuration Builder • 13
Using ProSoft Configuration Builder (PCB) for
Diagnostics • 59
Using the CommonNet Data Map • 17
Using the Diagnostic Window in ProSoft Configuration
Builder • 59
Using the Online Help • 12
W
What Is Covered By This Warranty • 152, 154
What Is Not Covered By This Warranty • 153
What's New • 11
Y
Your Feedback Please • 2