ProSoft Technology 5201-MNET-101S - Manual (Page 140)

IEC 60870-5-101 Slave Interoperability Statement IEC-101 Slave ♦ ProLinx Communication Gateway
Protocol Manual IEC 60870-5-101 v3 Slave (Firmware version 3.xx)
Page 140 of 159 ProSoft Technology, Inc.
August 6, 2010
6.8.10 Parameter Loading
(Object-specific parameter; mark " X" if function is only used in the standard
direction, " R" if only used in the reverse direction, and "B" if used in both
directions)

Threshold value
 Smoothing factor
 Low limit for transmission of measured value
 High limit for transmission of measured value
6.8.11 Parameter Activation
(Object-specific parameter; mark " X" if function is only used in the standard
direction, " R" if only used in the reverse direction, and "B" if used in both
directions)

Act/deact of persistent cyclic or periodic transmission of the addressed
object
6.8.12 Test Procedure
(Station-specific parameter; mark " X" if function is only used in the standard
direction, " R" if only used in the reverse direction, and "B" if used in both
directions)

Test procedure
6.8.13 File Transfer
(Station-specific parameter; mark " X" if function is used)
File transfer in monitor direction

Transparent file
 Transmission of disturbance data of protection equipment
 Transmission of sequence of events
 Transmission of sequence of recorded analogue values
File transfer in control direction

Transparent file