Native Instruments MASCHINE MK3 Groove Production Studio (Black) - Manual (Page 303)

6.4.2 Selecting a Scale and Creating Chords
MASCHINE comes equipped with a vast amount of scales and chords that you can select and
use to play your Sounds. This opens up possibilities to play an instrument such as a piano ac-
cording to, e.g., the minor pentatonic scale without hitting a “false” pad (note) on your control-
ler, or to play chords that always fit by hitting single pads.
The Scale and Chord engine is available only when your pads are in Keyboard mode.
This section provides a hands-on introduction to the use of scales and chords from your con-
troller. The corresponding parameters will be described in detail in section
↑ 6.4.3, Scale and
Chord Parameters .
6.4.3 Scale and Chord Parameters
This section describes the Scale and Chord engine and its parameters, and provides a list of all
scales and chords available on your controller.
General Notes on Scales and Chords
▪ The Scale and Chord parameters are the same for all Sound slots in a particular Group, you
can have different Scale and Chord parameters for each Group. The Scale and Chord pa-
rameters of each Group are saved with the Project. However, when you save a Group the
Scale and Chord parameters are
not saved with the Group.
▪ The Scale and Chord engine processes live input from the pads of your controller only. In-
put from third-party MIDI controllers and data recorded in the Pattern Editor are not proc-
essed by the Scale and Chord engine.
KOMPLETE KONTROL S-SERIES owners: Input from your KOMPLETE KONTROL S-SERIES key-
board can also be processed by the Scale and Chord engine. This is described in section Using the
Perform Features.
▪ The output of the Scale and Chord engine is recorded into the Pattern Editor.
▪ The Scale and Chord parameters cannot be modulated nor automated in MASCHINE.
Playing on the Controller
Performance Features
MASCHINE - Manual - 303