Fujitsu Ricoh Fujitsu SP-1425 Image Scanner - Manual (Page 73)

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
73
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
Scanning does not start.
Is the document loaded in the ADF paper chute (feeder)
correctly?
No
Reload the document in the ADF paper chute (feeder).
Yes
Is the ADF closed properly?
No
Close the ADF firmly.
If the document is caught in the ADF, remove the document and close the ADF.
Yes
Is the USB cable connected properly?
No
Connect the USB cable properly.
For details, refer to the Quick Installation Sheet.
Yes
Is the connector on the USB cable broken or damaged?
Yes
Use a new cable and make sure that it is connected properly.
No
Does scanning start after turning the scanner off then back
on?
Yes
The scanner is operating correctly.
No
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 86) first, then contact the distributor/dealer where you
purchased this product.