With a local or remote modem connection, Modem connections – Lucent Technologies MERLIN LEGEND 6 User Manual
Page 252
MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Managing the System
Page 6-22
Programming from a PC with SPM
6
With a Local or Remote Modem Connection
6
The method you use to access SPM by modem depends on whether you are
programming on site (locally) or from a remote location.
■
If you are on site, the modem must be connected to a 012 or a 016
(Release 4.0 and later only) module on the control unit. To establish a
connection to the control unit’s internal modem, dial
.
■
If you are at a remote location, do one of the following:
— Place a call to the system on a remote access line, enter the barrier
code (if required), and dial the code for the internal modem (
).
— Place a voice call to the system on a regular line and ask the operator to
transfer you to the modem (by dialing
Ã
). When you hear the modem
answer tone, switch to data mode.
Modem Connections
6
You must make a data connection to a modem. The following modem dialing
commands work for most modems. These may not be the commands your
modem uses; refer to the user guide that came with your modem for specific
information.
■
If the PC is in the same location as the control unit, type
.
■
If the PC is in a remote location and your system has activated the Remote
Access feature, type the following:
6U9U
, the remote access telephone number, and
X
.
Then press
I
For example:
6U9U ! $$$ !"#ÃX
I
. Also, a barrier code (4 to 11
digits) may be required between the
6U9U
and the
X
entries. For
example:
Ã6U9U ! $$$ !"#ÃX !"#$%&ÃX
.
■
When the connection is made, the password prompt appears on the
screen. (You may have to press
I
more than once to get the
password prompt.)
NOTE:
If you enter a telephone number of fewer than 11 digits, you must end it
with a pound sign (#).
■
If the PC is in a remote location and your system has not activated the
Remote Access feature, do the following:
1.
Use the main telephone number to place a voice call to the system.
2.
Instruct the operator to transfer the call to the modem by transferring
the call to
.
3.
Put the modem on line by switching it to data mode.