Canadian department of communications (doc) interf, Fcc notification and repairinformation, Fcc notification and repair information – Lucent Technologies MERLIN LEGEND 6 User Manual
Page 378: Fcc notification and repair information 1
MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Customer Support Information
Page A-2
Canadian Department of Communications (DOC) Interference Information
A
Canadian Department of
Communications (DOC)
Interference Information
1
This digital apparatus does not exceed the Class A limits for radio noise
emissions set out in the radio interference regulations of the Canadian
Department of Communications.
Le Présent Appareil Numérique n’émet pas de bruits radioélectriques dépassant
les limites applicables aux appareils numériques de la classe A préscrites dans le
règlement sur le brouillage radioélectrique edicté par le ministère des
Communications du Canada.
FCC Notification and
Repair Information
1
This equipment is registered with the FCC in accordance with Part 68 of its rules.
In compliance with those rules, you are advised of the following:
■
Means of Connection. Connection of this equipment to the telephone
network shall be through a standard network interface jack, USOC RJ11C,
RJ14C, RJ21X. Connection to E&M tie trunks requires a USOC RJ2GX.
Connection to off-premises extensions requires a USOC RJ11C or RJ14C.
Connection to 1.544-Mbps digital facilities must be through a USOC RJ48C
or RJ48X. Connection to DID requires a USOC RJ11C, RJ14C, or RJ21X.
These USOCs must be ordered from your telephone company. Connection
to 56-Kbps or 64-Kbps facilities requires a USOC RJ11C, RJ14C, or RJ21.
■
Party Lines and Coin Telephones. This equipment may not be used with
party lines or coin telephone lines.
■
Notification to the Telephone Companies. Before connecting this
equipment, you or your equipment supplier must notify your local telephone
company’s business office of the following:
— The telephone number(s) you will be using with this equipment.
The appropriate registration number and ringer equivalence number
(REN), which can be found on the back or bottom of the control unit,
as follows:
If this equipment is to be used as a Key system, report the number
AS593M-72914-KF-E.
If the system provides both manual and automatic selection of
incoming/outgoing access to the network, report the number
AS593M-72682-MF-E.