Panasonic KX-PS8100 - Manual (Page 138)

138
Installing Software for Macintosh
After you install the printer driver and printer description file, you need to set
up the KX-PS8100 in the Chooser. This section describes how to set up the
KX-PS8100 with the Adobe PostScript printer driver.
To set up the KX-PS8100 in the Chooser:
1 Click the Chooser from Apple (

) menu and ensure
AppleTalk is “Active”.
NOTE:
• If necessary, you may need to add the AppleTalk zone in which
your printer is located.
2 Click the AdobePS printer icon in the Chooser .
3 Select the name of the KX-PS8100 from the scroll list—
KX-PS8100_Direct, KX-PS8100_Print, or
KX-PS8100_Hold.
NOTES:
• “KX-PS8100_Direct” is typically selected.
• If the optional hard disk drive is not installed in the printer, only
KX-PS8100_Direct appears.
• The name of a printer corresponds to the system name you
edited when you configured a connection to the printer.
See
“System Setup” on page 156 .
4 Click [Create] or [Setup...] .
5 Confirm an icon appeared to the left of the printer name
selected in step 3, and click
[OK]
6 Select the name of the KX-PS8100.
7 Click [Setup...] .
8 In the window that appears, click [Configure] .
If your printer does not have additional devices installed, skip to
step 10 .
9 From the pop-up menus, specify the device options
installed on your printer. Click
[OK] .
This step must be completed to enable features in the printer driver
relating to devices installed on the printer.
Setting up the
KX-PS8100 in the
Chooser