Panasonic KX-PS8100 - Manual (Page 198)

198
Basic Operations
Before the printer can print after being in Ready(Sleep) , it needs to warm up
to heat up the fuser. The actual warm-up time depends on how long the
printer has been in Power Saver mode. If the printer has been in
Ready(Sleep) Power Saver mode for a long time, the warm-up period will be
longer.
If there is a printing problem, the Error indicator will be on, and an error will
appear in the display window. For information about error messages,
see
“Printer LCD panel” on page 248 .
The table below describes the printer’s main menus.
• Press the MENU/EXIT button to access the menus.
• Press the ▲ /CONTINUE or ⁄ /CANCEL button to scroll through the
menus.
Some of these menus (Parallel Port Setup, Network Port Setup, and
Network Protocol Setup) are used to configure the printer’s initial Setup,
which must be completed before users can send jobs to the printer. For
information on performing the initial Setup from the printer panel,
see
page 145 .
The Main menus are displayed in the upper line of the printer panel, and the
Selection menus are displayed in the lower line.
Main menus To specify Notes
Test Page Printing one of three sample
pages, stored in the printer’s
ROM: PS Font List, Test Print,
and Configuration page. See page 202
Printer’s error
messages
Printer’s main
menus
MENU
/EXIT
CONTINUE CANCEL
ENTER
READY
ERROR
(Continued)