Panasonic KX-PS8100 - Manual (Page 72)

72
Connecting the Printer to a Network
To connect a twisted pair cable to the printer:
1 Make sure the computer, printer and the other
connected peripheral devices are turned off.
2 Connect the RJ-45 cable to the RJ-45 jack on the back
of the printer.
3 Turn on the printer and then the computer.
For Ethernet speed setting, see “Network Port Setup” on page 146 .
The printer supports the shielded twisted pair cable (Category 5 shielded
twisted pair cable) that plugs into the RJ-45 jack on the back of the printer.
To connect the cable to RJ-45 jack on the printer:
1 Make sure the computer, printer and the other
connected peripheral devices are turned off.
2 Connect the cable from the Token Ring MAU (Media
Attachment Unit) to RJ-45 jack on the back of the
printer.
NOTE:
• A Media Attachment Unit (MAU) is a network hub for a Token
Ring Network.
3 Turn on the printer and then the computer.
For Token Ring settings, see “Network Port Setup” on page 146 .
Token Ring
network
connections
Parallel interface
connector
RJ-45 jack
(Use shielded cable only.)