Panasonic KX-PS8100 - Manual (Page 163)

163
Setup from the Printer Panel and WebSetup
NOTE:
• If your network uses both NDS and Bindery, set up NDS first. Setting up
NDS after Bindery will overwrite Bindery Setup. If your network uses both
NDS and Bindery, including using NetWare 4.x servers in bindery
emulation, the KX-PS8100 cannot service NDS and bindery emulation
servers on the same NDS tree.
PServer Setup (NetWare Services)
The Enable PServer mode option must be turned on if you have a Novell
server connected. You can change the PServer Poll Interval and modify
either Bindery Setup or NDS Configuration.
NOTE:
• To enable PServer mode you must first select a frame type. See “Select
Frames” on page 162 .
A) PServer Setup (NDS Configuration)
In initial setup, the KX-PS8100 was connected to the network and an NDS
directory tree, with a Printer, a Print Server, and one or more Print Queue
objects for KX-PS8100 jobs was configured (
see page 87 ). You can make
any changes to that setup through WebSetup. To modify NDS Setup you
may need permission to browse the NDS tree. If access to the Print Server
is restricted, you’ll need a login password.
Note that the terms NetWare server, Novell server, and IPX server are in
common use and are used here interchangeably to mean the server on an
IPX network running Novell NetWare networking software.
To set up the NDS configuration:
1 Check the Enable NDS check box.
NDS has already been enabled. Uncheck this box only to remove
NDS support.
2 Click [Change\Trees] to open the Add NDS Tree
window.
You can have only one NDS tree, so the following process is
required to change trees.
3 Select the current NDS tree and click [Remove] .