Panasonic KX-PS8100 - Manual (Page 174)

174
Color Calibration
To perform Bias Adjustment:
1a If you wish to adjust the density for all colors
simultaneously, perform the following, then go to
step 2 .
1) Repeat steps 1 through 3 in “To print a color
calibration page:” on page 171 .
“Calibration Offset” is displayed in the printer LCD panel.
2) Press the ENTER button.
“0*” (–5 to 5) is displayed in the printer LCD panel.
3) Press the ▲ /CONTINUE or ⁄ /CANCEL button to
darken/lighten all the colors.
To make the color density setting of the Color Calibration Page
darker or lighter by 1 level, increase or decrease a value of the
Calibration Offset by 3 by pressing the
▲
/CONTINUE or
⁄ /CANCEL button.
For example when Calibration Offset is 0:
• If you wish to make the density setting darker by 1 level:
—Select 3 by pressing the
▲
/CONTINUE button 3 times.
• If you wish to make the density setting lighter by 1 level:
—Select –3 by pressing the ⁄ /CANCEL button 3 times.
4) Press the ENTER button.
“CYAN” is displayed in the printer LCD panel.
5) Press the ▲ /CONTINUE button 4 times.
“Calibration Test Print” is displayed in the printer LCD panel.
1b If you wish to adjust the density for each color
independently, perform the following, then go to
step 2 .
1) Repeat steps 1 through 3 in “To print a color
calibration page”.
2) Press the ▲ /CONTINUE button.
“CYAN” is displayed in the printer LCD panel.
3) Press the ENTER button.
“0*” (–10 to 10) is displayed in the printer LCD panel.