Panasonic KX-PS8100 - Manual (Page 278)

278
Options
After you install the hard disk and power on the printer, you may be
prompted to initialize the new hard disk drive. If so, follow the directions
below:
1 From Ready or Ready(Sleep) , press the MENU/EXIT
button to enter the Setup menus.
2 Press the ▲ /CONTINUE button until “ Hard Disk ”
appears. Follow the instructions on the printer LCD
panel.
Installing additional memory
The following section explains how to install a 32 or 64 MB SDRAM
(Synchronous Dynamic Random Access Memory) DIMM (Dual In-line
Memory Module) on the KX-PS8100.
To install the SDRAM DIMM (illustrated below) you will need to do the
following:
• Remove the printer controller board from the back of the printer.
• Install a 32 or 64 MB SDRAM DIMM in either of the empty SDRAM slot on
the printer controller board.
• Replace the printer controller board.
IMPORTANT:
• To prevent static electricity damage to certain components ( see
page 272 ), touch a grounded metal surface, such as the printer’s bare
metal frame prior to touching the component.
• SDRAM DIMM
CAUTIONS:
• Do not drop or bend the SDRAM DIMM.
• Do not touch the connector edge of the SDRAM DIMM.
• Protect the SDRAM DIMM from static electricity by keeping it in its anti-
static package until you are ready to install it.
• Avoid exposing the SDRAM DIMM to direct sunlight, high temperatures,
or humidity.
Initializing the hard
disk
The shape of a
SDRAM DIMM is
subject to change.
Kit contents