Panasonic KX-PS8100 - Manual (Page 249)

249
Care and Maintenance
Flash
Device Failure
Flash DIMM hardware error. Cycle Power. If
printer does not function normally, call for
service.
Flash File
Operation Failed
Flash DIMM is functioning abnormally. Cycle
Power. If printer does not function normally,
call for service.
Front or Right door
Open
Close Front or Right door.
Fuser Unit
Not installed
Install a Panasonic fuser unit.
Fuser Unit
wearing out*
Fuser unit will need to be replaced soon.
Fuser Unit
Worn out
Replace the fuser unit.
Imaging Unit
No tension
Set the upper lever of the color imaging unit
to “Lock”.
Imaging Unit
Not installed
Install color imaging unit.
Imaging Unit
wearing out
Color imaging unit will need to be replaced
soon.
Imaging Unit
Worn out
Replace the color imaging unit.
Initializing Printer is initializing.
Insert printed pages in
MP tray, press Continue
Insert printed pages into multi-purpose (MP)
tray, then press the
▲ /CONTINUE button.
Insufficient
Memory
Not enough memory to finish printing.
Change printing resolution to 600 x 600 dpi if
you selected higher resolution.
or
Install additional memory in the printer.
Jam at A
See front door label
Clear paper jam. See printer’s front door
label. (
See page 221 .)
Jam at B
See front door label
Clear paper jam. See printer’s front door
label. (
See page 223 .)
Message Corrective Action/Additional Information
* Printing a large quantity of pages with high coverage will result in the
message “Fuser Unit wearing out” to be displayed earlier than its expected
life. In this case, replace the fuser unit.