161 setup from the printer panel and websetup – Panasonic KX-PS8100 User Manual

Page 161

Advertising
background image

161

Setup from the Printer Panel and WebSetup

Subnet Mask— If you need to set the subnet mask, enter one of the
following values:

255.0.0.0

if the IP address starts with a number less than 128

255.255.0.0

if the IP address starts with a number from 128 through 191

255.255.255.0

if the IP address starts with a number greater than 191

Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from
those listed.

Enable on Token Ring—Enable this option if you have a TCP/IP network
connected to the printer over Token Ring. If you use Token Ring, enabling
TCP/IP for Token Ring is required for enabling the Fiery WebTools.

IP Address—Enter KX-PS8100 IP address for Token Ring. The printer is
shipped with the IP address set to the loopback address, (127.0.0.1)

which

is an internal address used for network checking. If you plan to print with
TCP/IP, you must first assign the printer a unique network IP address. For
information about setting up printing with TCP/IP,

see “Connecting the

Printer to a Network” on page 70

.

Subnet Mask—If you need to set the subnet mask, enter one of the
following values:

255.0.0.0

if the IP address starts with a number less than 128

255.255.0.0

if the IP address starts with a number from 128 through 191

255.255.255.0

if the IP address starts with a number greater than 191

Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from
those listed.

Gateway—If your TCP/IP network has a gateway, and users outside the
gateway plan to print to the printer using TCP/IP, enter the gateway address
here. By default, the loopback address, 127.0.0.1, is set. Obtain the correct
gateway address from your network administrator.

Enable AppleTalk—Enable this option if you have an AppleTalk network
connected to the printer. This setting enables the printer to communicate
over AppleTalk networks.

Advertising