Panasonic MINAS A4P Series - Manual (Page 102)

102
How to Use the Console
Copying of Parameters from the Console to the Driver
Starting from initial LED status,Press six time after pressing , then press
to make a display to
Copying completes normally.
Error display
<Remarks>
If error is displayed,
repeat the procedures
from the beginning.
Press .
When you keep on pressing ,
a dot ( ) moves to the left.
The positioning parameter is
copied from the console into the
servo driver.
The servo parameter is copied
from the console into the servo
driver and the driver type code of
the servo parameter is written into
EEPROM (console).
<Remarks>
Don't disconnect the console from the driver between to .
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector,
misoperation due to noise or failure of console.
Press to call for
EXECUTION DISPLAY of
Keep pressing until
the console display (LED)
change.
“ ” increases by
pressing (approx. 3sec)
as the left fig. shows.
To move to the next process, press .
SELECTION display When you have finished the copy, press to return to .
Check whether or not to
transfer the read parameter
to the servo driver.
If a type code stored in EEPROM (console)
and another type code of servo driver are
different from each other.
Operation at SELECTION display
Operation at EXECUTION display