Panasonic MINAS A4P Series - Manual (Page 86)

86
How to Use the Console
Press .
Total sum of pulses after control power-ON.
The display range is from –2147483647 to 2147483647.
An overflow occurs if the result is outside the display range.
Sum of pulses shown can be reset to “0” by pressing
for approximately 5 seconds or more.
Press .
Press .
lowest (
order
)
highest (
order
)
Press .
* Not available to the models that do not
support external scale.
lowest (
order
)
highest (
order
)
Automatic Motor Recognizing Function
Automatic recognition is valid. (This is always shown.)
Switching of the Driver to be Communicated
RS232 communication
.....“1” is always shown.
Display of Feedback Pulse Sum, Command Pulse Sum
Display of External Scale Deviation, External Scale Feedback Pulse Sum
Display of Regenerative Load Factor
Display of Over-load Factor
Shows regenerative resistance load factor in percentage assuming that
an operation level of regenerative protection is 100%.
This is valid when SV.Pr6C is 0 or 1.
Displays the ratio (%) against the rated load.
Refer to P.170, "Overload Protection Time Characteristics" of When in Trouble.
Display of Inertia Ratio
Displays the inertia ratio (%) .
Value of SV.Pr20 (Inertia ratio) will be displayed as it is.