Panasonic MINAS A4P Series - Manual (Page 96)

96
How to Use the Console
• When you change the parameters which contents become valid after resetting, will be
displayed after finishing wiring. Turn off the control power once to reset.
Note 1) When writing error occurs, make writing again. If the writing error repeats many times,
this might be a failure.
Note 2) Don't turn off the power during EEPROM writing. Incorrect data might be written.
If this happens, set up all of parameters again, and re-write after checking the data.
Note 3) Between and , take care not to pull out a console connector from a servo
driver main unit. If the connector is pulled out accidentally, insert the connector again and retry
from the beginning.
<Notice>
When you have set the parameters, write the parameters into EEPROM. If you turn the power supply
off before writing the parameters into EEPROM, those parameters are cleared.
Starts writing.
Finishes writing
Writing completes Writing error
Starting from the initial LED status,
press three time after pressing ,
then brings the display of
EEPROM Writing Mode,
Keep pressing
until the display changes to when you execute writing.
“ ” increases while
keep pressing
(for approx. 5sec) as
the right fig. shows.
Press to make
EXECUTION DISPLAY to
To move to the next process, press .
EEPROM Write Mode
EEPROM Writing
Operation at SELECTION display
Operation at EXECUTION display