ZyXEL Communications IES-708-22A - Manual (Page 118)

Chapter 14 xDSL Profiles Setup
IES-708-22A User’s Guide
118
14.3 Port Profile Screen
To open this screen, click Basic Setting > xDSL Profiles Setup.
Figure 51 Basic Setting > xDSL Profiles Setup
The following table describes the labels in this screen.
Table 24 Basic Setting > xDSL Profiles Setup
LABEL DESCRIPTION
VC Profile Click VC Profile to open the VC Profile screen where you can configure virtual
channel profiles (see Section 14.7 on page 123 ).
Alarm Profile Click Alarm Profile to open the Alarm Profile screen where you can configure
limits that trigger an alarm when exceeded (see Section 14.8 on page 124 )
IGMP Filter Profile (STU-C mode only) Click IGMP Filter Profile to open the IGMP Filter Profile
screen where you can configure IGMP multicast filter profiles (see Section
14.10 on page 127 ).
Index This is the port profile index number.
Name These are the names of individual profiles. The DEFVAL profile always exists
and all of the DSL ports have it assigned to them by default. You can use up to
31 English keyboard characters; spaces are not allowed.
Max/Min Rate This field displays the maximum and minimum transfer rate for this profile.
Wire Pair This field displays how many pairs of wires the profile uses.
Select
Modify Select a profile’s Select radio button and click Modify to edit the profile.
Select
Delete Select a profile’s Select radio button and click Delete to remove the profile.
The rest of the screen is for profile configuration.
Name When editing a profile, this is the name of this profile. When adding a profile,
type a name (up to 31 characters) for the profile.
Max Rate Type a maximum transfer rate for this profile.