ZyXEL Communications IES-708-22A - Manual (Page 152)

Chapter 18 IGMP
IES-708-22A User’s Guide
152
The following table describes the labels in this screen.
18.5 IGMP Setup Screen
Use this screen to configure your IGMP settings.
To open this screen, click Advanced Application > IGMP > IGMP Setup.
Figure 70 Advanced Application > IGMP > IGMP Setup
The following table describes the labels in this screen.
Table 38 Advanced Application > IGMP > Bandwidth Setup > Port Setup
LABEL DESCRIPTION
Bandwidth Setup Click Bandwidth Setup to open the IGMP Bandwidth screen where you can
set up bandwidth requirements for multicast channels (see Section 18.4 on
page 150 ).
Port This field shows each DSL port number.
Active This field shows whether or not multicast bandwidth requirements are enabled
on this port. “V” displays if it is enabled and “-“ displays if it is disabled.
Bandwidth Enter the maximum acceptable multicast bandwidth for this port. This has no
effect if bandwidth requirements are disabled.
Select Select this, and click Active or Inactive to enable or disable the specified
multicast bandwidth requirements on this port.
Active Click this to enable the specified multicast bandwidth requirements on the
selected port.
Inactive Click this to disable the specified multicast bandwidth requirements on the
selected port.
Select All Click this to select all entries in the table.
Select None Click this to un-select all entries in the table.
Table 39 Advanced Application > IGMP > IGMP Setup
LABEL DESCRIPTION
IGMP Status Click IGMP Status to open the IGMP Setup screen where you can view current
IGMP information (see Section 18.3 on page 148 ).
Filter Setup (STU-C mode only) Click Filter Setup to open the IGMP Filter Profile screen
where you can configure IGMP multicast filter profiles (see Section 18.6 on
page 153 ).