ZyXEL Communications IES-708-22A - Manual (Page 275)

Chapter 44 Alarm Commands
IES-708-22A User’s Guide
275
"
Use the
alarm tablelist
command to display alarm setting details.
The following example creates an alarm report entry that sets all system alarms to the major
severity level and sends them to an SNMP server at the local 3 log facility.
44.11 Alarm Cutoff Command
Syntax:
ras> alarm cutoff
This command cancels an alarm. This stops the sending of the alarm signal current. This is
useful in stopping an alarm if you have the alarm output connector pins connected to a visible
or audible alarm. The alarm entry remains in the system.
44.12 Alarm Clear Command
Syntax:
ras> alarm clear
This command erases the clearable alarm entries.
ras> alarm xedit sys all major local3 syslog