ZyXEL Communications IES-708-22A - Manual (Page 301)

Chapter 48 IGMP Commands
IES-708-22A User’s Guide
301
The following example displays which IGMP filter profile DSL port 5 is using.
48.3.2 IGMP Filter Set Command
Syntax:
ras> switch igmpfilter set <portlist> <name>
where
This command sets a DSL port(s) to use an IGMP filter profile.
The following example sets DSL port 5 to use the voice IGMP filter profile.
48.3.3 IGMP Filter Profile Set Command
Syntax:
ras> switch igmpfilter profile set <name> <index> <startip> <endip>
where
This command configures an IGMP filter profile.
ras> switch igmpfilter show 5
port profile
--------------------------------------
5 DEFVAL
<portlist> = You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
<name> = The name of an IGMP filter profile.
ras> switch igmpfilter set 5 voice
<name> = Specify a name to identify the IGMP filter profile (you cannot
change the name of the DEFVAL profile). You can use up to 31
English keyboard characters; spaces are not allowed.
<index> = The number (1~16) to identify a multicast IP address range.
<startip> = Type the starting multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile.
<endip> = Type the ending multicast IP address for a range of IP addresses
that you want to belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both
the Start IP and End IP fields.