ZyXEL Communications IES-708-22A - Manual (Page 61)

Chapter 4 Introducing the Web Configurator
IES-708-22A User’s Guide
61
4.6 Changing Your Password
After you log in for the first time, it is recommended you change the default administrator
password. Click Basic Setting and then User Account to display the User Account screen.
Figure 13 User Account
Click the index number 1 to edit the default administrator account settings.
Access Control Use this screen to configure service access control and configure SNMP and
remote management.
Routing Protocol
Static Routing Use this screen to configure static routes. A static route defines how the IES-
708-22A should forward traffic by configuring the TCP/IP parameters manually.
Alarm
Alarm Status Use these screens to view the alarms that are currently in the system.
Alarm Event Setup Use these screens to view and set the severity levels of the alarms and where
the system is to send them.
Alarm Port Setup Use this screen to set the alarm severity threshold for recording alarms on an
individual port(s).
Management
Maintenance Use this screen to perform firmware and configuration file maintenance as well
as restart the system.
Diagnostic Use this screen to view system logs and test port(s).
MAC Table Use this screen to view the MAC addresses of devices attached to what ports.
ARP Table Use this screen to view the MAC address to IP address resolution table.
Config Save
Config Save Use this screen to save the device’s configuration into the nonvolatile memory
(the IES-708-22A’s storage that remains even if the IES-708-22A’s power is
turned off).
Table 4 Web Configurator Screens (continued)
LABEL DESCRIPTION